Only need to practice for 20 to 30 hours

You will get to know the valuable exam tips and the latest question types in our MSC-122 certification training files, and there are special explanations for some difficult questions, which can help you to have a better understanding of the difficult questions. All of the questions we listed in our MSC-122 practice exam materials are the key points for the IT exam, and there is no doubt that you can practice all of MSC-122 best questions within 20 to 30 hours, even though the time you spend on it is very short, however the contents you have practiced are the quintessence for the IT exam. And of course, if you still have any misgivings, you can practice our MSC-122 certification training files again and again, which may help you to get the highest score in the IT exam.

There is no doubt that the IT examination plays an essential role in the IT field. On the one hand, there is no denying that the MSC-122 practice exam materials provides us with a convenient and efficient way to measure IT workers' knowledge and ability(MSC-122 best questions). On the other hand, up to now, no other methods have been discovered to replace the examination. That is to say, the IT examination is still regarded as the only reliable and feasible method which we can take (MSC-122 certification training), and other methods are too time- consuming and therefore they are infeasible, thus it is inevitable for IT workers to take part in the IT exam. However, how to pass the Motorola Solutions MSC-122 exam has become a big challenge for many people and if you are one of those who are worried, congratulations, you have clicked into the right place--MSC-122 practice exam materials. Our company is committed to help you pass exam and get the IT certification easily. Our company has carried out cooperation with a lot of top IT experts in many countries to compile the MSC-122 best questions for IT workers and our exam preparation are famous for their high quality and favorable prices. The shining points of our MSC-122 certification training files are as follows.

Fast delivery in 5 to 10 minutes after payment

Our company knows that time is precious especially for those who are preparing for Motorola Solutions MSC-122 exam, just like the old saying goes "Time flies like an arrow, and time lost never returns." We have tried our best to provide our customers the fastest delivery. We can ensure you that you will receive our MSC-122 practice exam materials within 5 to 10 minutes after payment, this marks the fastest delivery speed in this field. Therefore, you will have more time to prepare for the MSC-122 actual exam. Our operation system will send the MSC-122 best questions to the e-mail address you used for payment, and all you need to do is just waiting for a while then check your mailbox.

Simulate the real exam

We provide different versions of MSC-122 practice exam materials for our customers, among which the software version can stimulate the real exam for you but it only can be used in the windows operation system. It tries to simulate the MSC-122 best questions for our customers to learn and test at the same time and it has been proved to be good environment for IT workers to find deficiencies of their knowledge in the course of stimulation.

After purchase, Instant Download: Upon successful payment, Our systems will automatically send the product you have purchased to your mailbox by email. (If not received within 12 hours, please contact us. Note: don't forget to check your spam.)

Motorola Solutions Deploy WLAN Solutions Sample Questions:

1. You are configuring two RFS7000 switches as a Primary and Redundant pair. On the Primary switch you notice that the System Status 2 LED on the Primary switch is Green Solid and the System Status 2 LED on the redundant switch is Amber Blinking. Which of the following best describes the current state of your installation? Please use the Status exhibit at the bottom.

A) Your Primary RFS7000 controller may not have the country code set correctly
B) If your Primary RFS7000 controller fails your redundant RFS7000 controller will need to be rebooted before it will work
C) The configuration on your redundant controller must be corrected before the system will work as designed
D) You will need to connect a Cat5 cable between the Primary and Redundant controllers before failover will work
E) System is configured and installed correctly

2. Following the installation of an RFS4000 controller with AP650 APs you use a popular WLAN discovery application to capture and display traffic to and from one of the APs. You notice that the majority of the transmitted frames are being sent at a very low speed, as shown in image below, even though the 802.11n connection supports a 130 Nbps signaling rate. What is the most likely cause of this condition?

A) An ACL policy has been configured to allow only 1 Mbps traffic, with the exception of Null Data frames, to traverse the Native VLAN.
B) Beacons are always transmitted at 1 Mbps. Acknowledgements to the Beacons must be sent at the same speed.
C) Non-unicast traffic is being transmitted at Lowest Configured Basic Rate.
D) A "Tar Pit" style Wireless Denial of Service (DoS) attack is underway from a nearby intruder.

3. You have just installed a 2.4 GHz WLAN at a customers call center location which houses many phone support agents using cordless headsets, keyboards, and mice. The main purpose of the WLAN is to allow floor managers to communicate using VoWLAN and mobile tablet PCs as they move throughout the office complex. Customers are complaining that they are experiencing poor voice quality with numerous dropped calls even though you have verified that the signal strength maintains a minimum RSSI of -67 dBm everywhere within the customer premises. In addition, you have used a spectrum analyzer to measure the noise floor and found that it averages about -82 dBm. What is the most likely reason for the poor quality of the WLAN?

A) Insufficient number of access points
B) Inadequate RSSI
C) Too many client devices
D) High Latency
E) Insufficient SNR

4. Wi-Fi radios can generally operate in the presence of transmissions from neighboring radios, as long as the neighboring signal strengths are at -85 dBm or lower. In Exhibit
3.3.10 shown below, ESSIDs Tin, Silver, Chrome, and Visitors are virtual APs assigned to a single Motorola AP-650 radio. Which of the neighboring ESSIDs are most likely to cause co-channel interference to this AP?

A) WLAN1g
B) beaglemama
C) 3AN1
D) Hidden SSID (MAC = 00:1C:F0:FA:65:94)
E) Moto

5. You have just completed the collection of Live RF measurement data using LANPlanner for the purpose of verifying the performance of a newly upgraded WLAN deployment. The customers reason for upgrading the previous system was to support VoWLAN in a multi-tenant office building using Motorola EWP3000 Smartphones. The original installation plan calls for an RSSI of -62 dBm from one primary AP per channel, with co-channel interference from nearby APs at a level of, no greater than, -85 dBm. In order to verify this condition you are checking 2.4 GHz Channel 11 and some additional overlapping channels which seem to have been mis-configured by neighboring WLANs.
Using the LANPlanner information shown in the two exhibits at the bottom, which of the following APs satisfies the requirements for a VoWLAN deployment using the prerequisites shown above?

A) 00:14:69:F2:B0:30 in Region 3
B) 00:14:69:F2:B0:30 in Region 2
C) 00:14:6A:07:F1:90 in Region 1
D) 00:A0:FS:BB:F6:60 in Region 1
E) 00:A0:FS:BB:F6:60 in Region 2

Solutions: